Hand-cut zellige is not a tile in the modern sense. Treating it like one is the single most common cause of a disappointing installation.
Every tile is a different size
Tiles are glazed as large squares, fired, then chiselled to shape by hand. A nominal 10 × 10 cm tile will in practice range by three or four millimetres in each direction, and thickness varies too. A tiler who expects machine tolerances will fight the material the whole way.
The glaze is meant to be uneven
Crazing, pooling and pinholes are inherent. Colour shifts across a batch, and across a wall, because the kiln is not uniform. This is exactly the quality that makes the surface move in changing light.
Specifying it properly
- Order 15% over your measured area — more for complex cuts
- Mix tiles from several boxes as you lay, rather than working box by box
- Use a tiler who has handled zellige before, and say so at quotation stage
- Seal before grouting and again after
Where it works
Kitchen splashbacks, bathrooms, fireplace surrounds, tabletops. Anywhere light rakes across it at an angle, which is where the hand-cut edge earns its keep.